Please be warned that the versions of ZFILER in this library were assembled¨
for use with my experimental version of the command processor.  Two cautions¨
must be observed.

ZFILER assumes that the CPR will autoinstall the program (Joe Wright's¨
autoinstall code is not included in ZFILER).  If you are not using ZCPR315¨
(or later) or have not installed the autoinstall modification into your¨
ZCPR30, be sure to preinstall ZFILER in the conventional way using Z3INS or¨
Z-RIP.

ZFILER also assumes the modification in the protocol for handling ZEX input¨
that I published some time ago.  If you are not running ZCPR315 (or later)¨
or have not modified your standard ZCPR30, ZEX will not run properly under¨
ZFILER.

Finally, please note the other compatibility issues described in ZF10A.DOC¨
concerning the ZFILER.CMD macro file.

As usual, your comments are solicited.  They may be sent to me at the places¨
below.  I also try to get onto the Ladera Z-Node #2 and the Lillipute nodes¨
fairly often.  Some other sysops will forward messages to me via PC-PURSUIT¨
(ask your sysop about that).  Remember, ZFILER is a user-supported ZSIG¨
program.  Please do not bother David McCord or Echelon with questions about¨
it.


			Jay Sage
			1435 Centre Street
			Newton Centre, MA 02159
			voice:  617-965-3552 (please do not get
			z-node: 617-965-7259  these numbers reversed!)