NODE104 - TELENET node repeat dialer
			    Version 1.4


 This program will repeat-dial remote Telenet nodes until a connection is
 made using various CP/M+ function calls. It looks for the Telenet command 
 prompt ("@") to determine that a non-connection condition has been deter-
 mined, and, when remote connection is detected, calls the remote
 modem, and sets it to the more informative Racal-Vadic mode.
 
 At this point, the user's communications program (presently set to MEX)
 is called, with the provision to include a script filename on the
 command line generated by NODE104 upon connection.

 User also has the options of returning to his/her communication program,
 to the operating system, disconnection, or trying a different remote node
 during the dialing cycle. Control-H at any time gives the user a brief help
 screen. 

 You will first need to select what assembler you are using (see "assembler
 selection;") and your operating system configuration.

 You will also need to insert the baudrate you wish to connect to at SPEED:,
 your Telenet identification string at label TNETID:, and your password at
 TNETPW.  Place the name of the program you wish to chain to at PRGRM:.
 Each definable section is enclosed in ''++++++++'' boundaries.

 Use your favorite editor in non-document mode, and use the assembler you
 have selected below to assemble and link.

 My special thanks to Ben Grey, sysop of Cedar Mills Z-Node #24, Portland,
 Oregon, for the extensive assistance.

					Mike Heffernan
					Hawthorne, CA
					July 19, 1988