PCPI RAM DISK INSTALLATION

	
	The RAM disk driver has been successfully installed in both
	A CPM 2.2 ver 2.0, with and without ZCPR3.  If your not using
	ZCPR3, then by all means convert.  It is a spectular enhance-
	ment to the standard operating system supplied by PCPI.  Nuff
	said about ZCPR3.  Install the driver in the same manner as
	you installed all of the other drivers.  Just read it in and
	write the modified drivers file out to the disk.  Simple!...
	If all else fails, there is allways the manual.

				** WARNING **

	The Ram disk alocates 59k of storage (drive D:) to the 6502 
	main memory space.  If you have the printer buffer installed,
	you must be cautious.  If you dump a large file, (40k+), to 
	the buffer, you might overwrite the RAM Disk.  I actually 
	don't know what happens, except that if you access one of the
	programs in the space, the system will hang. The printing 
	continues until done without loss of data though, so I really
	don't mind.  I can allways reload the RAM disk, but it is
	hard to reload the BUFFER!  Under most circumstances, there 
	is never a problem, and the driver performs without diff-
	iculty.

	If there are any questions/problems send them to me on one
	of the BBS's listed below:

		ZeeMachine:	(408) 245-1420
		SYSOP:		Norman Beeler

		Digikron:	(408) 253-1309
		SYSOP:		Doug Thom

		Potpourri:	(408) 378-7474
		SYSOP:		Wayne Masters


				-Signed-

			       Jim McMann
			       San Jose, Ca.